Sony GV-A500E, Service Manual

Page: 103 / 127

5-44
10. V-COM Adjustment (PD-88 baord)
Set the DC bias of the common electrode drive signal of LCD display
to the specified value.
If deviated, the LCD display will move, producing flicker and
conspicuous vertical lines.
Mode Playback pause
Signal Alignment tape:
LP mode operation check
(WR5-8NLE (NTSC))
(WR5-8CLE or WR5-4CL (PAL))
Color bar portion
Measurement point
Check on LCD display
Measuring instrument
Adjustment page D
Adjustment address 59
Adjusting method:
1)
Set page: 0, address: 01, data: 01.
2) Playback the alignment tape and set to the playback pause mode.
3) Change the data of page: D, address: 59. When the data is
increased from the initial value, vertical lines with intervals of
3 dots between them will be seen. Take the data at this times as
DA. When decreased from the initial value, the same vertical
lines will be seen. Take the data at this times as D
B
.
4) Convert D
A
and D
B
to decimal numbers to obtain D
A
´ and D
B
´.
(Refer to Table 5-1-5. “Hexadecimal notation-decimal notation
calculation table”.)
5) Calculate D
C
´ using the following equation (decimal
calculation).
D
C
´ = (D
A
´ + D
B
´) ÷ 2
6) Convert D
C
´ to hexadecimal number to obtain D
C
.
7) Set page: D, address: 59, data: D
C
and press the PAUSE button
of the adjusting remote commander.
8) Set page: 0, address: 01, data: 00.
Fig. 5-3-35.
Enlaargement
3 dots between
11. White Balance Adjustment (VC-197 baord)
Correct the white balance.
If deviated, the LCD screen color cannot be reproduced.
Mode VTR stop
Signal 10-step stair-step signal or color bar
signal whose chroma and burst signals
are turned off
Measurement point Check on LCD screen
Measuring instrument
Adjustment page D
Adjustment address 55, 56
Specified value The LCD screen should not be
colored.
Note : Check the white balance only when replacing the following
parts. If necessary, adjust them.
1. LCD panel
2. Light induction plate
3. IC801
Adjusting method:
1)
Set page: 0, address: 01, data: 01.
2) Check that the LCD screen is not colored. If colored, change
the data of page: D, address: 55 and 56 so that the LCD screen
is not colored.
Note :
To write in the non-volatile memory (EEPROM), press
the PAUSE button of the adjusting remote commander
each time to set the data.
3) Set page: 0, address: 01, data: 00.