Basic Functions
FCB-EH6300(GB) A-E23-100-13(1)
Basic Functions
Overview of Functions
The camera control is performed by VISCA
commands.
Timing Chart
As VISCA Command processing can only be carried
out one time in a Vertical cycle, it takes the maximum
1V cycle time for an ACKNOWLEDGE/Completion to
be returned.
If the Command ACKNOWLEDGE/Completion
communication time can be cut shorter than the 1V
cycle time, then every 1V cycle can receive a
Command.
Query Commands
General Commands
16 Byte
1) 1V cycle times on each Monitoring Mode and Shutter Speed.
Monitoring Mode
1080p/59.94
1080p/50
1080p/29.97
1080p/25
1080i/59.94
1080i/50
720p/59.94
720p/50
720p/29.97
720p/25
1/60 sec
1/50 sec
In general
• Power On/Off
Powers the camera on and off. When the power is off,
the camera is able to accept only the lowest level of
VISCA Commands; the display and other features are
turned off.
• I/F Clear
Clears the Command buffer of the FCB camera.
• Address Set
VISCA is a protocol, which normally supports a daisy
chain of up to seven connected cameras via RS-232C
interface. In such cases, the address set command can
be used to assign addresses from 1 to 7 to each of the
seven cameras, allowing you to control the seven
cameras with the same personal computer.
Although the FCB camera does not support direct
connection of cameras in a daisy chain, be sure to use
the address set command to set the address whenever
a camera is connected for the first time.
• ID Write
Sets the camera ID.
• Mute
Blanks the screen and sends out a synchronizing
signal.
• Lens Initialize
Initializes the zoom and focus of the lens. Even when
power is already on, it initializes the zoom and the
focus.
