Sony ECM-S930C Service Manual Download Page 2

2

ECM-S930C

SECTION 1

GENERAL

This section is extracted
from instruction manual.

A

Installing the battery (See fig. 

A

)

1

Open the battery compartment  lid.

2

Place the CR2025 battery  (not supplied)  with the + side facing upward.
Be sure to place the battery with polarity positioned  correctly.

Battery life

The Sony CR2025 lithium  battery  (not supplied)  gives continuous  operation  on the
microphone for about 350 hours. When you turn the power on, the battery check
indicator  lights momentarily.  When the battery  becomes weak,  the indicator  lights
dimly or does not light at all. In this case, replace the battery with a new one. (Sony
CR2025 lithium  battery  (not  supplied)).  To avoid  battery  wear  or leakage,  be sure  to
turn the power off after using the microphone.

When the battery compartment  lid comes off

1

Hold down part 

A

 with  a thumb  so that  it does  not  slide.

2

Insert one of the parts of 

A

 into  the  projecting  part 

B

 of the  battery  compartment

and then insert the other part while pressing toward the inside.

Removing the battery (See fig. 

B

)

When to replace the battery

When the power is turned on, the battery check indicator lights momentarily. When
the battery  become  weak,  the indicator  remains  dimly  lit or does not light at all. In this
case, replace the battery with Sony CR2025 lithium battery. Use of another battery may
present a risk of fire or explosion.
Under normal conditions of use, the battery will last approximately 350 hours.

Notes on lithium  battery

• Keep the lithium  battery  out of the reach of children.  Should  the battery  be

swallowed, immediately consult a 

doctor.

• Wipe the battery with a dry cloth to assure good contact.
• Be sure to observe the correct polarity when installing the battery.
• Do not hold the battery with metallic tweezers. Doing so can cause a short-circuit.

WARNING

Battery may explode  if mistreated.
Do not recharge,  disassemble  or dispose  of in fire.

1

2

B

1

2

+ side
pôle +
lado +

– side
pôle –
lado –

Lithium battery  CR2025 (not  supplied)
Pile au  lithium  CR2025  (non  fournie)
Pila de  litio  CR2025  (no  suministrada)

A

B

Parts Identification and Uses (See fig. 

D

)

1

Directive angle switch
Set the switch  according  to the sound  source.
90˚:

Use to pick up a relatively  narrower  sound  source  (instrumental  solo,
conversation, etc.), 

to 

provide a 

clear stereo sound image focused on target

source.

120˚: Use to pick up a relatively  wider  sound  source  (orchestra,  chorus,  stage

play, etc.), to provide  a natural  stereo sound image with full reality.

The above  are guidelines  for selecting  an appropriate  angle.  Although  following
these guidelines  is encouraged,  you can freely select either angle according  to
your own preference.

Note

If you switch the angle during recording, noise may occure.

2

Gold-plated triple-pole stereo miniplug

Connect to the MIC jack of your recording  equipment (video camera, etc.)

3

Battery compartment lid

4

Power switch

ON:

Select when  the microphone  works  with the battery.

OFF: Select when the microphone works with plug-in power or when you turn it

off.

When you use a Sony video camera with plug-in  power  system, set the power
switch to OFF.

5

Battery check indicator

When the power  is turned  on, this indicator  lights momentarily.  When the battery
becomes weak, the indicator  remains dimly lit or does not light at all. In this case,
replace the battery with a new one.

D

1

2

3

4

5

Summary of Contents for ECM-S930C









Reviews: