3-7
DXC-D30WS/P(E)/V1
3-3-6. Chroma (VBS) Level Adjustment
Equipment:
Verctorscope
To be extended: ES-22 board
Preparation:
• GAIN switch/Verctorscope
→
75 % CAL
• Adjust the PHASE control on the vectorscope so that
the burst spot is overlapped to the 75 % axis.
• OUTPUT/DL/DCC
+
switch/camera side
→
BARS
Test point:
VIDEO OUT connector/camera side
Adjustment Procedure:
1. [for NTSC]
• SERVICE menu “PAGE 7”
→
B-Y
BST :
Note:
In case of NTSC, make sure that “R-Y BST”
must be “0”.
• Adjust the UP
4
switch or DOWN
$
switch so that
burst spot is located at 75 % scale mark on the
vectorscope screen.
[for PAL]
• SERVICE menu “PAGE 7”
→
R-Y
BST :
B-Y
BST :
• Adjust “R-Y BST” and “B-Y BST” alternately by UP
4
switch or DOWN
$
switch so that burst spot is
located at 75 % scale mark on the vectorscope
screen.
2. Adjust the following controls alternately so that each
beam spot stays inside the reference frame “
4
”.
1
RV503 (B-Y LEV)/ES-22 board
1
FL502 (PHASE)/ES-22 board
1
RV504 (CHROMA VBS LEV)/ ES-22 board
3. Then, perform above procedure item 1 again.
[for NTSC]
[for PAL]
R
M
G
C
Y
G
Y
L
B
R
M
G
C
Y
G
Y
L
B
100%
75%
3-3-7. Y (VBS) Level Adjustment
Equipment:
Waveform monitor
To be extended: ES-22 board
Preparation:
OUTPUT/DL/DCC
+
switch/camera side
→
BARS
Test point:
VIDEO OUT connector/camera side
Adjustment Procedure
1. [for NTSC]
• SERVICE menu “PAGE 9”
→
SET UP
: ON
MAT DEST : SMPTE
• SERVICE menu “PAGE 5”
→
S-UP LVL :
Adjust the UP
4
switch or DOWN
$
switch.
Specification
: A = 7.5
±
0.5 IRE (See below
waveform) ---- NTSC only
[for PAL]
• SERVICE menu “PAGE 9”
→
COMP LVL : 525 (not 700)
2. Adjusting point:
1
RV501 (Y LEVEL)/ES-22 board
Specification:
[for NTSC] B = 100
±
2 IRE
[for PAL]
B = 700
±
10 mV
[for NTSC]
[for PAL]
DL504
DL503
CN501
RV505
C (Y-C)
RV501
Y (VBS)
RV502
Y (Y-C)
FL502
RV504
C (VBS)
RV503
B-Y LEV
FL501
E1
TP1
DL501
FL503
DL502
ES-22 BOARD -A SIDE-
