27
RF REMOTE Menu
For details on menu operation, see “Basic Menu
Operations” on page 23.
This receiver is equipped with the wireless remote control
function that can be used to set the parameters (low-cut
filter, attenuation operation, power save mode, etc.) of the
transmitter through the TRANSMITTER menu. This
function makes it easier to operate and manage the
microphone system while in the field.
This wireless remote control is 2.4 GHz IEEE802.15.4
compliant and has no effect on the RF band of digital
wireless audio.
This function is activated when pairing is established
between the transmitter and the receiver using the RF
REMOTE menu.
If the software version is not suitable for use with this
receiver, the wireless remote control function may not
function. A software update may be necessary to enable
proper functioning. For details on software updates,
contact your Sony service representative.
For details on transmitter software versions that are
compatible with this receiver, see “Transmitter software
version” on page 38.
Using the Cross Remote
(RF REMOTE)
This function must be set to allow the wireless remote
control function to be used between the transmitter and
receiver.
OFF:
Stops the wireless remote control function.
ON:
Starts the wireless remote control function with the
previously paired receiver.
Pairing With a Transmitter
(PAIRING)
Pairing links the receiver with the transmitter which the
wireless remote control function is to be used.
Set pairing configurations as follows:
1
In the RF REMOTE menu, rotate the jog dial to select
PAIRING, and then press the dial.
A message “START PAIRING?” appears.
2
Set the transmitter to be controlled to pairing mode.
For details on how to operate the transmitter, refer to
the operating instructions supplied with the
transmitter.
3
Rotate the jog dial to select YES, and then press the
dial.
The receiver starts searching for transmitters and then
displays the names of transmitters with which pairing
is possible.
During the search, pressing any operation key on the
receiver will cancel pairing mode.
4
Rotate the jog dial to select the transmitter to be paired
with from among those indicated, and then press the
dial to enter the setting.
The receiver starts to communicate with the selected
transmitter and the wireless remote control condition
appears in the display. The condition level (indicated
by
) goes up and the remote control function
becomes operative.
If the receiving channel (CH) configured on the receiver is
a channel for which use with the wireless remote control
function is restricted on the transmitter side, the
UNMATCH screen appears.
In such cases, change the receiving channel on the
receiver. If you want to use the restricted channel, set
REMOTE to OFF in the transmitter’s menu to release the
channel restriction, and manually configure the
transmitter’s channel.
On Cross Remote condition indication
Indicates the signal transmission condition of the wireless
remote control function (four levels).
: Good transmission
: Somewhat good transmission
: Somewhat poor transmission
: Poor transmission
: Unable to communicate with paired transmitter
When the wireless remote control function
off, this indication does not appear.
Using the Cross Remote with a previous
pairing
If the wireless remote control condition icon is displayed
on the top display of the receiver when the power of the
transmitter is ON, use is possible as is.
If the icon is not displayed, check whether the RF
REMOTE setting of the transmitter or receiver is set to
ON.
Note
Note
Cross Remote
condition indication
Summary of Contents for DWR-R02DN
Page 42: ...Sony Corporation ...
