1-1
ENGLISH
ENGLISH
DSC-T700_L2
1. SERVICE NOTE
1-4. PRECAUTION ON REPLACING THE SY-208 BOARD
Note 1:
When replacing the SY-208 board, erase the data in internal memory of the board before replacement.
Note 2:
When replacing the SY-208 board, execute formatting and initialize the internal memory after replacement.
DESTINATION DATA
When you replace to the repairing board, the written destination data of repairing board also might be changed to original setting.
Refer to Service Manual ADJ, and perform “DESTINATION DATA WRITE”.
USB SERIAL No.
The set is shipped with a unique ID (USB Serial No.) written in it.
This ID has not been written in a new board for service, and therefore it must be entered after the board replacement.
Refer to Service Manual ADJ, and perform “USB SERIAL No. INPUT”.
Angular Velocity Sensor
When you replace to the reparing board, write down the sensitivity displayed on the angular velocity sensor (SE511).
Refer to Service Manual ADJ, and perform “Angular velocity sensor sensitivity adj”.
PPP
YYY
YYY: YAW Sensor sensitivity
SE511
SY-208 BOARD (SIDE B)
PPP: PITCH Sensor sensitivity
1-1. NOTE FOR THE INTERNAL MEMORY
When a “Memory Stick Duo” is inserted in the camera, images are recorded on the “Memory Stick Duo”.
Note that the camera cannot copy or transfer images directly between the internal memory and a “Memory Stick Duo”. Use the “PMB”.
1-2. PASSWORD LOCK
Once the password is set, images in the internal memory cannot be played back.
In case of needing to read images in the internal memory from the password locked set, release the password locking.
Releasing the Password Lock
1. First turn off the camera’s power. Then press
(Playback) button while moving the zoom (W/T) lever to the W side.
2. The power is now turned on, and the password release screen apears
t
touch [OK]
3. Enter the password release number ‘7669’
t
touch [OK]
t
[OK]
(Playback) button
Zoom (W/T) lever
1-3. PMB PORTABLE
The application “PMB Portable” has already built in the internal memory.
The SY-208 board for repair is supplied with the built-in application “PMB Portable” .
In case of replacing the internal memory with new one, it is necessory to write the application “PMB Portable” in it.
For writing procedure, please refer to the PMB guide.
Note 3:
The sensor sensitivity of SE511 of SY-208 board is written only repair parts.
