Sony DSC-RX0M2, Help Manual

Page: 280 / 299

Help Guide
Digital Still Camera
DSC-RX0M2
About water-proof, dust-proof, and shock-proof performance of the camera
This camera has enhanced water-proof, dust-proof and shock-proof protection. Damage caused
from misuse, abuse or failure to properly maintain the camera is not covered by the limited
warranty.
This camera is water-proof/dust-proof equivalent to IEC60529 IP68. The camera is operable up to a water depth of
10 m (33 ft.) for 60 minutes.
Do not subject the camera to pressurized water, such as from a tap.
Do not use in hot springs.
Use the camera in the recommended operating water temperature range of 0°C to +40°C (32°F to 104°F).
As for shock-proof performance, this product has passed our in-company testing, which conforms to MIL-STD 810G
C1 Method 516.7-Shock (U.S. Department of Defense test method standard for shock), by dropping this product from
a height of 2.0 m (6.5 ft.) above a 5 cm (2 inches) thick plywood board*.
As for shock-proof performance, there is no guarantee that the camera will not become scratched or dented.
Sometimes water-proof performance is lost if the camera is subjected to a strong shock such as from being
dropped. We recommend the camera be inspected at an authorized repair shop for a fee.
Accessories supplied do not meet water-proof, dust-proof, and shock-proof specifications.
Notes before using the camera under/near water
About the battery cover and memory card/connector cover
Make sure that no foreign matter such as sand, hair, or dirt gets inside the battery cover or memory
card/connector cover. Even a small amount of foreign matter may lead to water entering the camera.
Always confirm that the battery cover or memory card/connector cover has been securely locked. The water-
proof/dust-proof performance is not ensured when the battery cover or memory card/connector cover is open.
When you open or close the battery cover or memory card/connector cover, ensure that the camera is completely
dry.
Do not open/close the battery cover or memory card/connector cover with wet or sandy hands or under/near
water. There is a risk this will lead to sand or water getting inside. Before opening the cover, perform the
procedure described in “
Cleaning after using the camera under/near water .”
About the sealing gaskets and surfaces in contact with the sealing gaskets
Testing was performed with the monitor of the camera in the closed position. In other situations, such as when the monitor of the camera is
in the open position, no guarantee is made regarding damage to, malfunction of, or the water-proof/dust-proof performance of this camera. *
280