10
Remote control
A
SLIDE SHOW button (page 18)
B
PRINT button (page 19)
C
MENU button* (page 18)
• Displays the Slide Show setting screen.
D
1
(on/standby) button (page 18)
• To turn on the printer, press
1
to turn on the
1
indicator in yellow green.
• To turn off the printer, press
1
again to turn
on the
1
indicator in red.
E
(Index) button
• Press the
side to switch to the index
screen.
• Press the other side to return to the single
image screen.
F
Control buttons (
v
/
V
/
b
/
B
/
)
• Press
v
/
V
/
b
/
B
to select images or change
the screen display.
• Press
to confirm the selection.
* For details, refer to the Instruction Manual
supplied with the camera and the Cyber-shot
Handbook.
P
Notes
• Remove the insulation sheet before using the
remote control.
• Point the remote control towards the remote
sensor on the camera adaptor to operate your
camera.
To change the battery of the remote
control
1
While pressing on the tab, inset your
fingernail into the slit to pull out the
battery case.
2
Place a new battery with the + side facing
up.
3
Insert the battery case back into the remote
control until it clicks.
Caution
Risk of Explosion if battery is replaced by an
incorrect type.
Dispose of used batteries according to
instructions.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble or dispose of in fire.
• When the lithium battery becomes weak, the
operating distance of the Remote Control may
shorten, or the Remote Control may not function
properly. In this case, replace the battery with a
Sony CR2025 lithium battery. Use of another
battery may present a risk of fire or explosion.
A
B
C
D
E
F
Insulation sheet
Tab
Summary of Contents for DPP-FPHD1 Instruction Manual (Photo Printer)
Page 31: ......
