1-2
DCR-VX2200E_L2
1-5. SELF-DIAGNOSIS FUNCTION
1-5-1. Self-diagnosis Function
When problems occur while the unit is operating, the self-diagnosis
function starts working, and displays on the viewfinder or LCD
screen what to do.
Details of the self-diagnosis functions are provided in the Instruction
manual.
1-5-2. Self-diagnosis Display
When problems occur while the unit is operating, the counter of the
viewfinder or LCD screen shows a 4-digit display consisting of an
alphabet and numbers, which blinks at 3.2 Hz. This 5-character
display indicates the “repaired by:”, “block” in which the problem
occurred, and “detailed code” of the problem.
1 1
3 1
C
Repaired by:
Refer to “1-5-3. Self-diagnosis Code Table”.
Indicates the appropriate
step to be taken.
E.g.
31 ....Reload the tape.
32 ....Turn on power again.
Block
Detailed Code
Blinks at 3.2Hz
C : Corrected by customer
H : Corrected by dealer
E : Corrected by service
engineer
Viewfinder or LCD screen
C : 3 1 : 1 1
1-4. USING SERVICE JIG
Connect the CPC-13 jig (J-6082-443-A) to the CN1004 on the VC-597 board.
Pin No.
Signal Name
Pin No.
Signal Name
1 (20)
REG_GND
11 (10)
EEP_SO_C
2 (19)
RF_MON
12 (9)
EEP_SO_S
3 (18)
REG_GND
13 (8)
EEP_SCK_C
4 (17)
SWP
14 (7)
EEP_SCK_S
5 (16)
FRRV
15 (6)
D_2.8V
6 (15)
REG_GND
16 (5)
MD2_C
7 (14)
GND
17 (4)
MD2
8 (13)
GND
18 (3)
XCS_MC_FLASH_C
9 (12)
EEP_SI_C
19 (2)
XCS_MC_FLASH
10 (11)
EEP_SI_S
20 (1)
XSYS_RST
Note: The pin number in ( ) is test terminal number of
CN1004 on the VC-597 board.
1
20
CN1004
VC-597 BOARD (SIDE B)
11
10
20
1
1
20
CPC-13
(J-6082-443-A)