Troubleshooting
74
Recording
An unknown picture appears on the
screen.
• The camcorder is in [DEMO MODE]. ([DEMO MODE] is automatically
displayed when you leave the camcorder for 10 minutes after selecting
CAMERA without inserting a cassette.)
c
Touch on the LCD screen or insert a cassette to cancel [DEMO
MODE]. You can also set [DEMO MODE] to [OFF] on the
(SETUP MENU) menu. (p. 58)
An unknown indicator appears on the
screen.
c
Refer to the indicator list. (p. 97)
The buttons do not appear on the
touch panel.
c
Touch the LCD panel lightly.
c
Press DSPL/BATT INFO (or DISPLAY on the Remote Commander).
(p. 37)
The buttons on the touch panel do not
work correctly or do not work at all.
c
Adjust the screen ([CALIBRATION]). (p. 87)
The picture in the viewfinder is not
clear.
c
Extend the viewfinder. (p. 16)
c
Use the viewfinder lens adjustment lever to adjust the lens. (p. 16)
The picture in the viewfinder has
disappeared.
c
Close the LCD panel. The picture is not displayed in the viewfinder
when the LCD panel is open. (p. 16)
The picture remains on the LCD
screen.
• This occurs when your camcorder is turned off forcibly by removing the
battery pack, disconnecting the DC plug from your camcorder or the like
while turning on the power. This is not a malfunction.
Symptom
Cause and/or Corrective Actions
The tape does not start when you
press REC START/STOP.
c
Slide the POWER switch to select the CAMERA mode. (p. 15)
c
The tape has reached the end. Rewind it, or insert a new cassette.
c
Set the write-protect tab to REC or insert a new cassette. (p. 82)
c
The tape is stuck to the drum due to moisture condensation. Remove the
cassette and leave your camcorder for at least 1 hour, then re-insert the
cassette. (p. 86)
The power abruptly turns off.
• [A.SHUT OFF] in the
(OTHERS) menu is set to [5min]. (p. 60)
c
When approximately 5 minutes have elapsed while you do not operate
your camcorder, the camcorder is automatically turned off.
Slide the POWER switch down to turn the power on again. (p. 15) Or
use the AC Adaptor.
c
Charge the battery pack. (p. 12)
The SteadyShot function does not
function.
c
Set STEADYSHOT to [ON] in the
(CAMERA SET) menu. (p. 48)
Auto focus does not function.
c
Set [FOCUS] to [
AUTO]. (p. 30)
c
The recording conditions are not suitable for auto focus. Adjust the focus
manually. (p. 30)
A vertical band appears when
recording candlelight or electric light
in the dark.
• This occurs when the contrast between the subject and the background is
too high. This is not a malfunction.
Symptom
Cause and/or Corrective Actions
