2-11
DSC-W80/W85_L2
4
Apply the lubricant (SRX-4339) to the nuruto gear, and insert it into the ring assembly.
* Rotate the gear in the ring assembly in the arrow direction until the end of the gear is not engaged
with a concave portion of the ring assembly (because a convex portion of the rear assembly enters
the convex portion).
5
Install the zoom gear block on the rear assembly.
6
Engaging four bosses, install the rear assembly on the ring assembly.
* The vibration-proof flexible board must be engaged with the hook of the rear assembly.
7
Tighten four screws in the order of
A
to
D
.
*
Tightening torque = 0.049
±
0.01N
•
m (0.5
±
0.1kgf
•
cm)
8
Check that the projection of the nuruto shaft that protrudes from the rear assembly is within the
specified value given below.
*
Specified value: 0.005 – 0.395mm
4
Nuruto gear
Ring assembly
Ring assembly
7
Four screws
Hook
6
Vibration-proof
flexible board
Nuruto shaft
Nuruto shaft
5
Zoom gear block
6
Rear assembly
Convex portion
Gear
Boss
Boss
0.005 – 0.395mm
8
D
A
B
C