2-10
DSC-W220_L2
q;
Molds
4
Screw
7
Screw
3
Optical Stepping Motor
1
Solders
8
Zoom Gear Block
6
Lens Rear Block
Check if the hook fits with the shaft
Check if the shaft fits with the groove.
2
Check the state of each part
Lens Rear Block
Installation
1
Install the lens flexible board with four solders.
2
Referring to the following figure, check each part state of lens rear block.
3
Install
Optical
Stepping
Motor.
4
Tighten one screw.
*
Tightening torque = 0.049
±
0.01N
•
m (0.5
±
0.1kgf
•
cm)
5
Rotate the gear of lens barrel in arrow direction to extend the lens.
6
Check the inside of lens barrel and the lens for dust or stain, and then install the lens rear block.
7
Tighten three screws.
*
Tightening torque = 0.049
±
0.01N
•
m (0.5
±
0.1kgf
•
cm)
8
Install Zoom Gear Block by referring to the installation
4
to
6
in "2-5-1. Zoom Gear Block Replacing Method".
9
Connect the connector of lens flexible board.
q;
Assemble the lens flexible board with the mold of Lens Block.
qa
Engage the lens flexible board with the claw.
5
qa
Claw
9
Connector
