DSC-T1
2-1
2-2
2-1. DISASSEMBLY
The following flow chart shows the disassembly procedure.
SY
-95
HELP 05
HELP 07
HELP 04
HELP 09
HELP 08
(disassembly of the Battery holder section)
1
1
1
Copper leaf protection sheet
2
Flexible board (from LSV-850A)(21P)
3
FP-695 board (Including the LD-140 board)
4
Radiation sheet (CCD)
5
Insulating sheet (CCD)
6
Two tapping screws (B1.2
´
3.5)
1
2
3
5
6
7
8
2
1
Turn over the
control switch
block
in the direction of the arrow.
2
LCD unit (ACX500EN-J) (25P)
1
FP-693 flexible board (16P)
2
Two claws
1
Tape (LCD)
2
Four screws (M1.4
´
2.5),
lock ace, p2 (special)
3
Screw (M1.4
´
2.5),
lock ace, p2 (special)
4
Slide the mode knob
9
Cabinet (rear) assembly
4
Mode knob
1
Four claws
2
1
2
LCD frame
2
Two claws
4
Two solderings
3
Microphone holder
5
Microphone
2
1
3
4
6
6
Microphone cushion
1
Harness protection sheet
7
Control switch block
(PW-125)
1
Remove the solderings
2
Four claws
1
2
4
Block light
guide plate
3
LCD unit (ACX500EN-J)
3
Remove the control switch
block in the direction of the arrow.
5
C
ontrol switch block,
LCD frame
6
LCD unit (ACX500EN-J)
Block light guide plate
7
Zoom button
8
SW button
1
Five screws (M1.4
´
2.5),
lock ace, p2 (special)
2
Cabinet (front) assembly
2
1
1
2
1
1
3
3
Lens shaft
1
FP-695 board (21P)
2
CCD block
assembly (33P)
3
Lens section
Note:
Be careful not to drop
the lens shaft.
The power capacitor of the flash unit is charged up to 315 V maximum. If you touch
the capacitor terminal that is charged to high voltage, you will receive an electric
shock. This high voltage is not discharged even if you turned off the main power
of this set, and it residues. Discharge the residual voltage referring to the service
note (page 1-1).
Note:
1
FP-690 flexible
board (19P)
2
ST-86 board,
ST terminal cover
HELP 01
HELP 02
HELP 03
HELP 06
3
FP-695 board (Including the LD-140 board)
7
CCD block
assembly
Note:
The CCD imager is not supplied
as a single unit since removing it
as a single unit requires adjustment.
Note:
Do not peel off the radiation sheet as
much as possible. If you peel it off, be
careful not to damage the flexible board.
8
LSV-850A
2
4
1
6
5
Note:
When re-assembling,
confirm the switch position.
(Sheet attachment positions and procedures of processing
the flexible boards/harnesses are shown.)
HELP
HELP
2
1
3
Battery holder
section
SECTION 2
DISASSEMBLY
