Sony Cyber-shot DSC-RX100M4, Service Manual

Page: 71 / 100

4-3. Lens Block
4-3-1. Ornamental Ring (A) or Barrier Block Assy Replacing Method
Removal
1. Turn on the power switch and extend the lens (WIDE end).
2. Detach the battery.
3. Apply alcohol to the gap of the Ornamental Plate using tweezers or fine-tipped stick as shown below.
4. Detach the Ornamental Ring (A).
Boss
Solvent
Tweezers
Ornamental Ring (A)
Do not turn the Ornamental Ring (A) because there is a
Positioning Boss. Detach the Ornamental Ring A in the
arrow direction.
Note:
Ornamental Ring (A)は，位置決めのボスがあるため，
左右にひねらず矢印方向に取り外してください。
Note:
5. Disengage the four claws and remove the Barrier Block Assy.
Barrier Assy
Claws
Claws
Installation
1. Fit the four claws while inserting the barrier lever into the hole and attach the Barrier Block Assy.
Hole
Barrier
Lever
Barrier Block Assy
Claws
Claws
2. Peel off the release paper of the Barrier Tape.
DSC-RX100M4
4-23