DSC-HX20/HX20V/HX30/HX30V_L2
1-13
6
7
Turn the Naruto Gear jig clockwise to set the Main body at TELE end.
Note:
Turn the Naruto Gear jig to the maximum.
Disengage the four Convexes on the Flexible Boards from the four Claws and pull the Flexible Boards out of the holes.
8
9
Turn the Naruto Gear jig counterclockwise to set the Main body to the retracted state.
Note:
Turn the Naruto Gear jig to the maximum.
Further turn the Gear clockwise (approx. 5 degrees) and remove the Stationary Tube from the Main body.
Flexible Boards
Naruto Gear jig
Naruto Gear jig
Stationary Tube
Gear
Main body
Holes
Claw
Claw
Claws
Outside
1-
11
. CAM TUBE (B) ASSY REPLACING METHOD
1
2
3
Peel off the Adhesive Tape.
Note:
Removed Adhesive Tape must not be reused. Use new Adhesive Tape.
Disconnect the Flexible Board from the Connector.
Remove solder at four locations to detach the three Bosses and the Convex on the Flexible Board.
4
5
Remove the six screws and remove the Rear Mirror Plate Assy and the Zoom Motor Gear Block.
Pull out the Naruto Gear.
Adhesive Tape
Removal
Solders
Boss
Boss
Flexible Board
Boss
Convex
Screws
Screws
Rear Mirror Plate Assy
Zoom Motor Gear Block
Naruto Gear
Naruto Gear
(4-424-720-01)
Hole
Fine-tipped screwdriver.
(or thin stick such as bamboo skewer)
Fix with bond or
equivalent.
Prepare a Naruto Gear (4-424-720-01) and a fine-tipped screwdriver (or thin stick such as bamboo skewer).
Insert a fine-tipped screwdriver (or thin stick such as bamboo skewer) into the Naruto Gear hole and fix the
Naruto Gear and the screwdriver with bond or equivalent.
Creation of Naruto Gear jig
The changed portions from
Ver. 1.0 are shown in blue.
Ver. 1.1 2012.05
