![background image](http://html.mh-extra.com/html/sony/cmt-ws2d/cmt-ws2d_operating-instructions-manual_420472062.webp)
62
GB
Tuner
Severe hum or noise/stations cannot be
received. (“TUNED” or “STEREO” flashes in
the display)
• Set the proper band and frequency (page 42).
• Connect the antenna properly (page 9).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical equipment.
A stereo FM program cannot be received in
stereo.
• Press FM MODE repeatedly until “MONO”
disappears.
Optional components
There is no sound.
• Refer to General item “There is no sound.”
(page 58) and check the condition of the system.
• Connect the component properly (page 55) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
Use buttons on the unit for the operation.
1
Disconnect the power cord.
2
Reconnect the power cord.
3
Press
?/1
to turn on the system.
4
Press
x
, SOUND FIELD and
?/1
at the
same time.
The system is reset to the factory settings except
for DVD settings. You should set the settings
you made, such as the preset stations, clock, and
timer.
To return the DVD setup to the
default settings
*
, perform reset
as follows:
1
Press
DISPLAY in stop mode.
2
Press
M
or
m
repeatedly to select “SETUP”,
then press ENTER.
3
Press
M
or
m
repeatedly to select “RESET”,
then press ENTER.
4
Press
M
or
m
repeatedly to select “YES”,
then press ENTER.
It takes a few seconds to complete. Do not
press
?/1
when resetting the system.
* Except for Parental Control settings