16
GB
Tuner
Severe hum or noise/stations cannot be
received.
• Set the proper band and frequency (page 10).
• Connect the antenna properly (page 4).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Consult your nearest Sony dealer if the supplied
AM antenna has come off the plastic stand.
• Try turning off surrounding electrical equipment.
A stereo FM program cannot be received in
stereo.
• Press FM MODE on the remote until “FM ST”
appears in the display.
Optional components
There is no sound.
• Refer to General item “There is no sound.”
(page 15) and check the condition of the system.
• Connect the component properly (page 14) while
checking:
–if the cords are connected properly.
–if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
• Press FUNCTION repeatedly until “PC” (or
“MD” or “TAPE”) appears (page 14).
The sound is distorted.
• Set the volume of the connected component
lower.
If the system still does not
operate properly after performing
the above measures, reset the
system as follows:
With the system turned on, press
x
,
FUNCTION and
?/1
at the same time.
The system is reset to the factory settings. You
should set the settings you made, such as the
preset stations, clock, and timer.
One of the following messages may appear or
flash in the display during operation.
CD
NO CD
There is no disc in the player.
OVER
You have reached the end of the disc while pressing
and holding
M
on the remote during playing
pause.
READ
The CD player is reading the TOC information of
the CD.
PUSH/STOP
You pressed PLAY MODE on the remote during
playback.
“PUSH” and “STOP” alternately appear in the
display.
Messages
