![background image](http://html.mh-extra.com/html/sony/cmt-cp500md/cmt-cp500md_operating-instructions-manual_420293021.webp)
MD — Recording
21
GB
To add “LP:” at the beginning of a
track name during MDLP recording
“LP:” appears when you try to play the track on
a system that does not support MDLP mode.
This convenient function lets you know at a
glance that the track cannot be played back.
The factory setting is “On”.
1
Press FUNCTION repeatedly until “MD”
appears in the display.
2
Press MENU/NO on the remote repeatedly
until “Setup Menu” appears.
3
Press
.
or
>
on the remote until “LP
Stamp On” (or “LP Stamp Off”) appears,
then press ENTER/YES on the remote.
4
Press
.
or
>
on the remote to select
the setting, then press ENTER/YES on the
remote.
To
Select
Add “LP”
LP Stamp On (factory
setting)
Cancel adding “LP”
LP Stamp Off
5
Press MENU/NO on the remote.
Notes
• The recorded “LP:” is a stamp which appears to
indicate that the track cannot be played back when
you try to play the track on system that does not
support MDLP mode. It does not appear for systems
that support MDLP mode.
• When set to “On”, “LP:” is recorded as the track
name, so the number of characters that can be input
to an MD is reduced. In addition, when you copy a
track name with “LP:” added, “LP:” is
automatically added to the copied track name. If
you divide an “LP:” track using the Divide function,
“LP:” is also added to the latter track.
Marking track numbers
• Automatically during recording
Track numbers are automatically marked as on
the original source during recording from this
system’s CD player. Use the Level-Synchro
Recording function to automatically mark track
numbers during recording from this system’s
tuner or components connected to the
ANALOG IN jack.
• At any point during recording
You can mark track numbers during recording
of any source (see page 22).
• After recording
Use the Divide Function (see page 29).
Marking track numbers
automatically during recording
— Level-Synchro Recording
The Level-Synchro Recording function is
factory set to on, so the track numbers are
automatically marked. If “L-SYNC” does not
appear during recording, turn on the Level-
Synchro Recording as follows. Track numbers
are automatically marked when the input signal
is continuously below a certain level for more
than 2 seconds and then exceeds that level.
Notes
• You cannot mark track numbers automatically if the
sound source to be recorded is noisy (e.g., tapes or
radio programs).
• Only one track number might be assigned when the
same single track of the same CD is recorded
repeatedly.
1
Press FUNCTION repeatedly until “MD”
appears in the display.
2
Press MENU/NO on the remote repeatedly
until “Setup Menu” appears in the display.
3
Press
.
or
>
on the remote
repeatedly until “T.Mark Off” (or “T.Mark
LSync”) appears, then press ENTER/YES
on the remote.
4
Press
.
or
>
on the remote
repeatedly to select the setting, then press
ENTER/YES on the remote.
To
Select
Turn on the Level Synchro
Recording function
T.Mark LSync
(factory setting)
Turn off the Level Synchro
Recording function
T.Mark Off
When you set the Level Synchro Recording
function, “L-SYNC” lights up.
5
Press MENU/NO on the remote.
To continue and record, follow the
procedures described on the various
recording pages.
continued
Summary of Contents for CMT-CP500MD
Page 55: ...Additional Information 55GB ...