17
17
CFD-EX35L
Note on Schematic Diagram:
• All capacitors are in µF unless otherwise noted. p: pF.
50 WV or less are not indicated except for electrolytics
and tantalums.
• All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
2
: nonflammable resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
H
: adjustment for repair.
• Total current is measured with no cassette installed.
• Power voltage is dc 9 V and fed with regulated dc power
supply from battery terminal.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
• Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
• Circled numbers refer to waveforms.
• Signal path.
F
: FM
f
: MW/LW
E
: PB
a
: REC
J
: CD
• WAVEFORMS
– TUNER Section –
SECTION 5
DIAGRAMS
5-1. Circuit Boards Location
Note on Printed Wiring Boards:
•
X
: parts extracted from the component side.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Note: The components identified by mark
0
or dotted line
with mark
0
are critical for safety.
Replace only with part number specified.
– TC Section –
– CD Section –
– MAIN Section –
BATT board
PDW board
MAIN board
L-R/REG board
TRANS board
LCD board
BATT COM board
POWER board
TUNER board
HEADPHONE board
CONTROL (CD) board
CONTROL (POWER) board
CONTROL (VOL) board
CD board
TC board
Summary of Contents for CFD-EX35L
