40
Error displays/Message
*1
When the CD/MD changer is connected to the unit,
the disc number of the CD or MD appears in the
display.
*2
The disc number of the disc causing the error
appears in the display.
If these solutions do not help improve the
situation, consult your nearest Sony dealer.
Radio reception
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
The stations cannot be received.
The sound is hampered by noises.
• Connect a power aerial control lead (blue) or
accessory power supply lead (red) to the
power supply lead of a car’s aerial booster.
(Only if your car has a built-in FM/MW/LW
aerial in the rear/side glass.)
• Check the connection of the car aerial.
• The auto aerial will not go up.
t
Check the connection of the power aerial
control lead.
• Check the frequency.
• When the DSO mode is on, the sound is
sometimes hampered by noises.
t
Set the DSO mode to “OFF” (page 31).
Automatic tuning is not possible.
• The local seek mode is set to “ON.”
t
Set the local seek mode to “OFF”
(page 30).
• The broadcast signal is too weak.
t
Perform manual tuning.
The “STEREO” indication flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set to the monaural reception mode
(page 30).
A programme broadcast in stereo is heard
in monaural.
The unit is in monaural reception mode.
t
Cancel monaural reception mode
(page 30).
RDS
Seek starts after a few seconds of listening.
The station is non-TP or has weak signal.
t
Press
(AF)
or
(TA)
repeatedly until
“
” or “
” disappears.
No traffic announcements.
• Activate TA function.
• The station does not broadcast any traffic
announcements despite being TP.
t
Tune in another station.
PTY displays “--------.”
• The current station is not an RDS station.
• RDS data has not been received.
• The station does not specify the programme
type.
A F
T A
Error displays
(For this unit and optional CD/MD changers)
The following indications will flash for about
5 seconds, and an alarm sound will be heard.
Blank
*
1
No tracks have been recorded on an MD*
2
.
t
Play an MD with recorded tracks on it.
Error
*
1
• A CD is dirty or inserted upside down.*
2
t
Clean or insert the CD correctly.
• A CD/MD cannot play because of some
problem.*
2
t
Insert another CD/MD.
High Temp
The ambient temperature is more than 50°C.
t
Wait until the temperature goes down
below 50°C.
NO Disc
No disc is inserted in the CD/MD unit.
t
Insert discs in the CD/MD unit.
NO Magazine
The disc magazine is not inserted in the CD/
MD unit.
t
Insert the magazine in the CD/MD unit.
NO Music
*
1
A CD which is not a music file is inserted.
t
Insert a music CD.
Not Ready
The lid of the MD unit is open or the MDs are
not inserted properly.
t
Close the lid or insert the MDs properly.
Push Reset
The CD/MD unit cannot be operated because
of some problem.
t
Press the reset button on the unit.
Message
Local Seek up/Local Seek down
The Local Seek mode is on during automatic
tuning (page 16).
