5
CDX-GT81UW/GT860U
SECTION 1
SERVICE NOTE
SERVO BOARD
CN2
MAIN BOARD
CNP301
J-2502-076-1
EXTENSION CABLE AND SERVICE POSITION
When repairing or servicing this set, connect the jig (extension cable)
as shown below.
• Connect the MAIN board (CNP301) and the SERVO board (CN2)
with the extension cable (Part No. J-2502-076-1).
NOTE FOR THE OPENING OF THE FRONT PANEL
In this set, the front panel is lowered to below the bottom face when
it is opened.
When servicing the set, place it on a stand having a height of about
2 cm.
NOTE FOR REPLACEMENT OF THE SERVO BOARD
When repairing, the complete SERVO board (A-1177-357-A) should
be replaced since any parts in the SERVO board cannot be repaired.
stand
NOTE FOR REPLACEMENT OF THE USB CONNECTOR
(CN903)
To replace the USB connector requires alignment.
1. Insert the USB connector into the front panel.
2. Place the DISPLAY board on the front panel and align the
terminals of the USB connector with the holes in the DISPLAY
board.
3. Solder the four terminals of the connector.
DISPLAY board
front panel
USB (socket) connector
Summary of Contents for CDX-GT81UW - Usb Receiver
Page 54: ...54 CDX GT81UW GT860U MEMO ...
