20
Error displays/Messages
Card remote commander operation is not
possible.
Make sure the insulation film has been removed
(page 4).
DSO does not function.
Depending on the type of car interior or type of music,
DSO may not have a desirable effect.
The images change automatically.
In Auto Image mode, the selected image cannot be
displayed.
t
To display selected image only, set to “Auto Image
off” (page 12).
Any display items do not display.
t
Set to “Info All” (page 12).
Cannot adjust the volume level
(AUX)
The portable audio device was not connected when
AUX was selected as
(SOURCE)
.
t
Connect the portable audio device to the AUX input
jack.
CD/MD playback
The disc cannot be loaded.
• Another disc is already loaded.
• The disc has been forcibly inserted upside down or in
the wrong way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 16).
• The disc format and file version are incompatible
with this unit (For details, refer to page 4 and 16).
MP3/WMA/AAC files take longer to play back
than others.
The following discs take a longer time to start
playback.
– a disc recorded with a complicated tree structure.
– a disc recorded in Multi Session.
– a disc to which data can be added.
The ATRAC CD cannot play.
• The disc is not created by authorized software, such
as SonicStage or SonicStage Simple Burner.
• Tracks that are not included in the group cannot be
played.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• “Auto Scroll” is set to off.
t
Set to “Auto Scroll on” (page 13) or press
(SCRL)
.
The sound skips.
• Installation is not correct.
t
Install the unit at an angle of less than 45° in a
sturdy part of the car.
• Defective or dirty disc.
The operation buttons do not function.
The disc will not eject.
Press the RESET button (page 4).
Radio reception
The stations cannot be received.
The sound is hampered by noises.
• Connect a power antenna (aerial) control lead (blue)
or accessory power supply lead (red) to the power
supply lead of a car’s antenna (aerial) booster (only
when your car has built-in FM/AM antenna (aerial)
in the rear/side glass).
• Check the connection of the car antenna (aerial).
• The auto antenna (aerial) will not go up.
t
Check the connection of the power antenna
(aerial) control lead.
• Check the frequency.
• When the DSO mode is on, the sound is sometimes
hampered by noises.
t
Set the DSO mode to “off” (page 11).
Preset tuning is not possible.
• Store the correct frequency in the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• The local seek mode is set to “on.”
t
Set to “Local off” (page 13).
• The broadcast signal is too weak.
t
Perform manual tuning.
During FM reception, the “ST” indication
flashes.
• Tune in the frequency accurately.
• The broadcast signal is too weak.
t
Set to “Mono on” (page 13).
An FM program broadcast in stereo is heard in
monaural.
The unit is in monaural reception mode.
t
Set to “Mono off” (page 13).
Blank Disc
*
1
Tracks have not been recorded on the MD.
*
2
t
Play an MD with recorded tracks.
Error
*
1
• The disc is dirty or inserted upside down.
*
2
t
Clean or insert the disc correctly.
• A blank disc has been inserted.
• The disc cannot play because of some problem.
t
Insert another disc.
Failure
The connection of speakers/amplifiers is incorrect.
t
See the installation guide manual of this model to
check the connection.
Failure
(Illuminates for about 1 second.)
When the SAT tuner is connected, storing an SAT
radio channel into a preset failed.
t
Be sure to receive the channel that you want to
store, then try it again.
Load
The changer is loading the disc.
t
Wait until loading is complete.
Local Seek +/–
The local seek mode is on during automatic tuning.
