9
Receiving a station through a
list — list-up
You can list up the frequency or the name. For
details on labelling a station, see page 10.
1
Select the band, then press
(LIST)
.
The frequency or station name appears.
2
Press
(LIST)
repeatedly until the
desired station appears.
After 5 seconds, the unit returns to normal
reception mode.
3
Press
(SEEK)
–/+ to receive the
station.
With the card remote commander
In step 2, to select the station, press
M
or
m
.
Other functions
Changing the sound
settings
Adjusting the sound
characteristics — BAL/FAD/SUB
You can adjust the balance, fader, and subwoofer
volume.
1
Press the select button repeatedly
until “BAL,” “FAD” or “SUB” appears.
The item changes as follows:
LOW
*
1
t
MID
*
1
t
HI
*
1
t
BAL
(left-right)
t
FAD
(front-rear)
t
SUB
(subwoofer volume)*
2
*1
When EQ3 is activated (page 9).
*2
When the audio output is set to “SUB”
(page 10).
“ATT” is displayed at the lowest setting, and can
be adjusted up to 20 steps.
2
Rotate the volume control dial
repeatedly to adjust the selected item.
After 3 seconds, the setting is complete and
the display returns to normal play/reception
mode.
Note
Adjust within 3 seconds of selecting the item.
With the card remote commander
In step 2, to adjust the selected item, press
<
,
M
,
,
or
m
.
Adjusting the equalizer curve
— EQ3
You can adjust and store the equalizer settings
for different tone ranges.
1
Select a source, then press
(EQ3)
repeatedly to select the EQ3 type.
2
Press the select button repeatedly
until “LOW,” “MID” or “HI” appears.
3
Rotate the volume control dial
repeatedly to adjust the selected item.
The volume level is adjustable in 1 dB steps,
from –10 dB to +10 dB.
Repeat steps 2 and 3 to adjust the equalizer
curve.
continue to next page
t
