Sony CDP-K1000, Operating Instructions Manual

Page: 13 / 16

13
Notes on CDs
On handling CDs
• To keep the disc clean, handle the disc by its edge. Do not
touch the surface.
• Do not stick paper or tape on the disc.
Not this way
• Do not expose the disc to direct sunlight or heat sources
such as hot air ducts, nor leave it in a car parked in direct
sunlight as there can be considerable rise in temperature
inside the car.
• Do not use any commercially available stabilizer. If you do,
the disc and the player may be damaged.
• After playing, store the disc in its case.
On cleaning
• Before playing, clean the disc with a cleaning cloth. Wipe
the disc from the centre out.
• Do not use solvents such as benzine, thinner, commercially
available cleaners or anti-static spray intended for vinyl
LPs.
Troubleshooting
If you experience any of the following difficulties while
using the player, use this troubleshooting guide to help
you remedy the problem. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound.
/ Check that the player is connected securely.
/ Make sure you operate the amplifier correctly.
The CD does not play.
/ There’s no CD inside the player (“no dISC” appears).
Insert a CD.
/ Place the CD with the label side up on the disc tray
correctly.
/ Clean the CD (see page 13).
/ Moisture has condensed inside the player. Remove
the disc and leave the player turned on for about an
hour (see page 2).
Specifications
Compact disc player
Laser
Semiconductor laser (
λ
= 780 nm)
Emission duration: continuous
Laser output Max 44.6
µ
W*
* This output is the value measured at
a distance of 200 mm from the
objective lens surface on the Optical
Pick-up block with 7 mm aperture.
Frequency response 2 Hz to 20 kHz ± 0.5 dB
Signal-to-noise ratio
More than 97 dB
Dynamic range More than 90 dB
Harmonic distortion Less than 0.007%
Channel separation More than 86 dB
Outputs
LINE OUT
General
Power requirements 220 V – 240 V AC, 50/60 Hz
Power consumption
10 W
Dimensions (approx.) 355
×
95
×
310 mm
(w/h/d) incl. projecting parts
Mass (approx.) 2.9 kg
Supplied accessories
Audio cord (2 phono plugs – 2 phono plugs) (1)
Feet (2)
Design and specifications are subject to change without notice.
Load
impedance
Over 10 kilohms
Jack
type
Phono
jacks
Maximum
output
level
2 V
(at 50 kilohms)
Additional Information