Sony CDP-CX250, Service Manual

Page: 17 / 72

— 17 —
SENSOR ALIGNMENT
If the disc table swings to the left and right just before the disc is
chucked, perform the following adjustment.
Fixed screw
Tapering screwdriver
Luminus board
Bracket (sensor)
Lever (stopper) assembly
Disc table
(2) Check that the lever (stopper) assem-
bly secures the disc table as shown in
the figure.
(1) Rotate the cam and adjust to the position
shown in the figure.
Cam
Bracket (sensor)
Table assembly
Swing
LEVER (stopper)
assembly
Cam
PAUSE button
PLAY button
(3) Loosen the fixed screw by 60
°
to 90
°
, and use a tapering screwdriver to adjust the screw as shown in the figure.
Move the bracket (sensor) with the tapering screwdriver little by little, and fix the fixed screw at where the play button's LED (green) is
switched to the pause button's LED (orange) (or its reverse).
(4) Moving the disc table right and left with a hand after the screw is
fixed, the table will move by the play of a disc table. If the LEDs
light up alternately, the adjustment will be performed correctly.