Sony CCP-1100SF, Service Manual

Page: 9 / 50

1-5
CCP-1100SF
8
Duplication
Five-minute warming up is recommended before
starting the unit. During warming up, you can clean the
heads (see page 10).
1
2
3 4
To rewind the tape(s) independently, insert only the
cassette(s) to be rewound and then press the REWIND
button. Each tape will be rewound to the beginning
and will stop.
To stop the tapes, press the STOP button.
Adjust the playback level controls by watching the
level meters.
Normally set them to the center position.
To use the additional CCP-1400 duplicator
Turn ON the POWER switch of the CCP-1400 and
insert copy cassettes. By operating the master
duplicator, duplication will begin on the additional
duplicator simultaneously.
1
Set the POWER switch to ON. The indicator lights
up. Allow 4 seconds for warming up.
POWER
ON
OFF
to a wall outlet
2
Insert the original cassette and the copy cassette.
3
Select the cassette side to be duplicated.
A: for one side of the cassette.
A + B: for both sides of the cassette.
SIDE SELECT
A
A B
4
Press the AUTO COPY button or COPY button.
AUTO COPY: To rewind each tape, start
duplicating and rewind to the beginning again.
COPY: To start duplicating immediately without
rewinding.
AUTO COPY COPY
See next page.
9
When the AUTO COPY or COPY button is pressed,
the operation of the original and copy tapes is
controlled as in the following table.
* If the SHORT TAPE indicator is lit, the tape is not
rewound.
SHORT TAPE Indicator
The SHORT TAPE indicator lights to show that a copy
tape was so short that the duplication may not have
been made completely and that a check is required.
When a copy tape reaches the end before the end of the
original tape, it stops but the original tape continues
running. The SHORT TAPE indicator will light. The
SHORT TAPE indicator will go off by pressing any
button but STOP.
End of the tape
Not duplicated
Original tape
Copy tape
SHORT TAPE
Note
When a copy tape reached the end just a moment after
the end of the original tape, the SHORT TAPE
indicator may light even if duplication is complete. To
confirm duplication use a cassette recorder to play
back near the end of the copy tape. The indicator also
lights when there is no tape in the cassette
compartment.
AUTO COPY
AUTO COPY COPY
Rewind Stop with beep Duplicating Rewind
Beginning of
both the tapes Beginning of
both the tapes
End of the tapes
COPY
AUTO COPY COPY
Duplicating
End of the
original tape
Automatic operating mode
Stop with beep
*