68
Making and Checking Network Settings
RMU-01 network settings
Install the setup tool supplied with the RMU-01 on the computer and make the RMU-01 network settings from
the computer.
Procedure
Start the RMU-01 setup tool on the computer.
Click the [Search Devices] button.
Note
On some computers equipped with multiple LAN ports (either wired or wireless), the RMU-01 units connected
to the LAN will not be detected even after you click the [Search Devices] button. In such cases, temporarily
disable all ports including those for LAN and IEEE1394 connections via [Network Connections] on the operating
system, and enable only the port to which the RMU-01 is connected. Then, restart the RMU-01 setup tool and
perform auto detection again.
RMU-01 devices present on the network are detected, and information about them is displayed.
Select the device for which to make the setting, and click the [Setting] button.
Specify the device name, IP address, and subnet mask.
Set the first three fields to the same values for each device.
Use a unique value for the fourth field only.
Specify a different segment from
other wireless networks in the vicinity.
Select the model number of the transmitter to be controlled
from the RMU-01 in [Target TX].
The optimal remote control channel will be selected based
on the specified transmitter and appear in [Remote CH].
You can select [Custom] to freely select the remote control
channel. If radio interference exists between the RMU-01
remote control and other systems such as wireless LAN,
you may be able to avoid the interference by selecting the
remote control channel with [Custom] enabled.
Set to 255.255.255.0
Notes
When [Custom] is selected, the automatic selection of the optimal remote control channel for the
transmitter will be ignored. In such cases, signals from the transmitter may affect remote control. Be sure to
verify operation before beginning actual use.
Depending on the operating environment of your computer, certain operations may be blocked by the
firewall or security filter after startup of the RMU-01 setup tool. If LAN communication that is necessary for
operation in NT mode is blocked, the system will not operate properly. Therefore, configure the firewall or
security filter to allow RMU-01 setup tool operations.
Step
Ch
Configuring a DWX System
