1-9 (E)
BVE-700A
1-7. Rack Mounting
The BVE-700A is mounted in the 19-inch standard rack.
To mount the BVE-700A in the rack, use the specified rack
mount kit and follow the procedure described below.
Specified rack mount kit : RMM-10
n
If a rack mount kit other than the specified one is used, the
unit may not be mounted in the 19-inch standard rack.
Parts of the RMM-10
.
Rack tools
2 pcs
.
Right rack mount adapter
1 pc
.
Left rack mount adapter
1 pc
.
Rack tool attaching screws
6 pcs
(B4
x
6 : 7-682-560-09)
.
Rack tool attaching screws
6 pcs
(B4
x
10 : 7-682-560-10)
1. Precautions for rack mounting
w
.
To prevent the rack from falling or moving, fix the rack
on a flat and steady floor using bolt or others.
If the rack falls due to the weight of the equipment, it
may cause death or injury.
.
Be sure to use the specified rack mount kit.
If not, injury may result and the equipment may fall due
to insufficient strength.
.
After rack mounting, be sure to tighten the screws on the
rack angle and fix the unit in the rack.
If the screws on the rack angle are not tightened, the unit
may slip from the rack and fall, causing injury.
c
When mounting the unit in the rack, note the following:
.
Be sure to mount in the rack with two persons or more.
.
Be careful not to catch your fingers or hands in the rack
mount rail or others.
.
Mount in the rack in a stable position.
n
If several units are mounted in a rack, it is recommended to
install a ventilation fan to prevent temperature rise inside
the rack.
2. Rack mounting procedure
This section describes the rack mounting procedure using
the RMM-10 rack mount kit.
n
Tighten the screws to the following torque.
Tightening torque : 120
x
10
_
2
N
.
m {12.2 kgf
.
cm}
1.
Attach the rack tool to the side of the equipment using
the specified six screws.
n
Use B4
x
6 screws.
2.
Loosen the screws on the rear of the right and left
adapters and adjust the length of the adapter according
to the depth of the rack.
(The illustration below shows the left adapter.)
n
Maximum depth of adapter : 750 mm
Minimum depth of adapter : 595 mm
B4
x
6
B4
x
6
B4
x
6
Portion of
the rail
Adapter
