1-12 (E)
BVE-700
B4
x
10
(with drop-safe)
B4
x
10
(with drop-safe)
B4
x
10
(with drop-safe)
Front panel
3.
Attach the right and left adapters to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adapter.)
4.
Tighten the screws (B4
x
6 : two screws each on the
right and left) for adjusting the length of the adapter
completely (the screws that were loosened in step 2).
5.
Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
6.
Turn off the main power of this unit and disconnect the
plug from the outlet.
7.
Fully loosen the four screws (with drop-safe) and
remove the front panel.
8.
Fix the rack angle in the rack using the specified
screws.
9.
Attach the front panel to the equipment.
1-8. Installing the BKE-701
For the installation procedure, refer to “4. Installation” of
the Installation Manual supplied with the BKE-701.
B4
x
10
3U
B4
x
10
31.75
31.75
Unit : mm
Rack tool
Rack tool
Rail
Rail
B5
x
12
B5
x
12
1-7. Rack Mounting
1-8. Installing the BKE-701
