F:\Shirayanagi\BRC300\BRU300.300P\3854214021_BRU300.300P\02GB01PL-WW.fm
masterpage: Left
BRU-300/300P
3-854-214-02 (1)
GB
2
Owner’s Record
The model and serial numbers are located on the top.
Record these numbers in the spaces provided below.
Refer to these numbers whenever you call upon your
Sony dealer regarding this product.
Model No.
Serial No.
To prevent fire or shock hazard, do not
expose the unit to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified
personnel only.
WARNING
THIS APPARATUS MUST BE EARTHED.
WARNING
The mains plug on this equipment must be used to
disconnect mains power.
Please ensure that the socket outlet is installed near the
equipment and shall be easily accessible.
In the event of abnormal operations, disconnect the
mains plug.
Laser Notice :
This product contains an optical fiber connecter using
laser that complies with IEC 60825-1.
This product is classified as a CLASS 1 LASER
PRODUCT.
Laser Diode information ( Optical Fiber Connector )
Wavelength 830 - 850 nm
CAUTION
The use of controls or adjustments or performance of
procedures other than those specified herein may result
in hazardous radiation exposure.
CAUTION
Do not look at the end of optical connector with naked
eyes or through optical equipment while the power is
supplied to this product. Otherwise, your eyes may be
injured.
ATTENTION
The electromagnetic fields at the specific frequencies
may influence the picture of this unit.
For customers in the U.S.A.
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio
or television reception, which can be determined by
turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the
following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and
receiver.
– Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV
technician for help.
If you have any questions about this product, you may
call:
Sony's Business Information Center (BIC) at
1-800-686-Sony (7669)
or Write to: Sony Customer Information Services
Center
6900-29, Daniels Parkway, PMB 330
Fort Myers, Florida 33912
You are cautioned that any changes or modifications not
expressly approved in this manual could void your
authority to operate this equipment.
The shielded interface cable recommended in this
manual must be used with this equipment in order to
comply with the limits for a digital device pursuant to
Subpart B of Part 15 of FCC Rules.
INTERFACE CABLE
This device requires shielded interface cables to comply
with FCC emission limits.
WARNING
Declaration of Conformity
Trade Name:
SONY
Model No:
BRU-300
Responsible Party: Sony Electronics Inc.
Address:
16450 W.Bernardo Dr, San Diego,
CA 92127 U.S.A.
Telephone number: 858-942-2230
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference,
and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
02GB01-WW.book Page 2 Tuesday, June 15, 2004 3:17 PM
