Sony BRC-H800, Operating Instructions Manual

Page: 64 / 65

64
SYSTEM SELECT switch settings
The image output method (video format) for the HDMI
OUT/SDI OUT terminals can be set with this switch.
• Be sure to set this switch before you turn on the
camera.
Turn on the power after you set the switch.
• Be sure to use a Phillips-head screwdriver when
changing the switch position. If you use a tool other
than the designated screwdriver, the crossed groove
may be damaged.
Pin array of the VISCA RS-422
terminal and how to use it
Pin array of VISCA RS-422 terminal
Connection diagram with remote control
unit RM-IP10
•
Connect the GNDs of both devices together to
stabilize the voltage level of the signal.
• When preparing cables, use network cables of
category 5e or more. Use cables equivalent to or
higher than shielded twisted pair cables.
No. Image size/Frame rate
BRC-X1000 BRC-H800
0 3840×2160/29.97p No output
1 1920×1080/59.94p 1920×1080/59.94p
2 1920×1080/59.94i 1920×1080/59.94i
3 No output No output
4 1280×720/59.94p 1280×720/59.94p
5 No output No output
6 No output No output
7 HDMI: 640×480/59.94p
SDI: 1280×720/59.94p HDMI: 640×480/59.94p
SDI: 1280×720/59.94p
8 3840×2160/25p No output
9 1920×1080/50p 1920×1080/50p
A 1920×1080/50i 1920×1080/50i
B No output No output
C 1280×720/50p 1280×720/50p
D No output No output
E 3840×2160/23.98p No output
F 1920×1080/23.98p 1920×1080/23.98p
Notes
EXT S YNC IN
TERMI-
NATION
ON OFF
ON
ON
OFF
LINE OUT
S DI 1
O S D
LAN
S DI 2
2 3 4 5 6 7 8 1
MONITOR OUT HDMI OUT
S DI 1 S DI 2
IN
S Y S TEM
S ELECT
IR S ELECT CAMERA S ETUP
1 2 3
VI S CA R S - 422 OUT
12V
Select your desired
video output format
Pin No. Function Pin No. Function
1 TX– 1 RX–
2 TX+ 2 RX+
3 RX– 3 TX–
4 GND 4 GND
5 GND 5 GND
6 RX+ 6 TX+
7 N.C. 7 N.C.
8 N.C. 8 N.C.
Notes
1 8
IN
1 8
OUT
1 9
1 8
RM-IP10
1 N.C.
2 N.C.
3 N.C.
4 N.C.
5 GND
6 RX–
7 RX+
8 TX–
9 TX+
Camera
1 TX–
2 TX+
3 RX–
4 GND
5 GND
6 RX+
7 N.C.
8 N.C.
Shield