2
RHT-G800
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40
°
C higher than
ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350
°
C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong viscosity
Unleaded solder is more viscous (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
Subwoofer
Speaker system
Bass-reflex, magnetically shielded type
Speaker unit
10 cm cone type
×
2
General
Power requirements
US, Canadian model:
120 V, 60 Hz
European model:
230 - 240 V, 50/60 Hz
Other models:
220 - 240 V, 50/60 Hz
Power consumption
On: 110 W
HDMI CONTROL is ON: 1.5 W or more
Standby (HDMI CONTROL is OFF): 0.3 W
Dimensions (approx.)
1,115
×
495
×
400 mm
(w/h/d) incl. projecting parts
Mass (approx.)
59 kg
Supplied accessories
Optical cable (1 m) (1)
Remote commander (remote) (1)
Size AA (R6) batteries (2)
Top glass panel (1)
Shelf board (1)
Screw (4)
Corner protector (4)
Operating Instructions (1)
HDMI CONTROL Guide (Operating
Instructions of HDMI CEC) (1)
Design and specifications are subject to change without notice.
SAFETY-RELATED COMPONENT WARNING!!
COMPONENTS IDENTIFIED BY MARK
0
OR DOTTED LINE
WITH MARK
0
ON THE SCHEMATIC DIAGRAMS AND IN THE
PARTS LIST ARE CRITICAL TO SAFE OPERATION. RE-
PLACE THESE COMPONENTS WITH SONY PARTS WHOSE
PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR
IN SUPPLEMENTS PUBLISHED BY SONY.
ATTENTION AU COMPOSANT AYANT RAPPORT
À LA SÉCURITÉ!!
LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE
0
SUR LES
DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.
Dimensions:
mm
A
1,115
B
400
C
495
Weight: kg
59