25
O
p
era
ting th
e TV
Programming the Remote
Control
The remote control can be programmed to operate
other equipment and is pre-programmed to operate
the following Sony equipment.
Follow the steps below to program your TV
remote control.
1
Find the code that corresponds to your
equipment from page 26. If more than one
code is provided, try programming the first
code listed.
2
Press and hold
DVD
,
AMP
or
STB
simultaneously with the
INPUT
button and
release. When in the programming mode, the
FUNCTION
button blinks for approximately
30 seconds until a code is entered.
3
Enter the five digit code using
0-9
. while the
FUNCTION
button is lit. If the code is not
entered within 30 seconds, you must repeat
step 2.
4
Press
or
ENT
to confirm the code. If
successfully programmed, the
FUNCTION
button blinks twice; if not, it blinks five times.
~
• Any of the
FUNCTION
buttons can be programmed to
operate other equipment regardless of the labeling. For
example,
DVD
can be programmed to operate a Blu-
ray player.
Confirm the Programming
If you can turn your equipment on and off using
the green
POWER
button, the programming is
complete. If not, try the next code listed.
~
• In some cases, you may not be able to program your
remote control. If this is the case, use your equipment’s
own remote control.
The backlight can be set to light up when a button
is pressed.
To set backlight:
Press
LIGHT
and
MUTING
simultaneously until
the four
FUNCTION
buttons blink red.
To turn off backlight:
Press
LIGHT
and
MUTING
until the
TV
button
blinks red.
The remote control can be set to remain lit longer
than the default time setting of approximately five
seconds with the
FUNCTION
buttons.
To change backlight time setting:
1
Press
LIGHT
,
VOL+
, and then
CH+
simultaneously until the
FUNCTION
button
blinks red.
2
Select the
FUNCTION
button that corresponds
to your preferred time out setting and press
.
To reset the remote control to the factory default
settings, press
SOUND
,
TV POWER
, and then
. The
FUNCTION
buttons blink red
simultaneously when successfully reset.
Function Button
Sony Equipment Code Number
DVD
DVD Player
31033
AMP
Receiver
52172
STB
Digital Satellite
01639
Programming Other Equipment
DI
S
PLAY
VOL CH
DVD AMP
S
TB
TV
PREV REPLAY
ADVANCE NEXT
THEATER
S
OUND PICTURE WIDE
CC FREEZE
LIGHT POWER
TV POWER
S
YNC MENU
PAU
S
E
PLAY
FUNCTION
S
TOP
2
3
2
4
Auto Backlight
Backlight Time Out
DVD
5 seconds (default)
AMP
10 seconds
STB
15 seconds
TV
20 seconds
Reset the Remote Control
