Sony BRAVIA KDL-32R420A, Operating Instructions Manual

Page: 9 / 48

9
GB
Start-u
p Guide
6: Auto-tuning
the TV
1
Press
F
/
f
to select the broadcast type,
then press .
2
Press
F
/
f
to select “Antenna” or
“Cable”, then press .
Select “Antenna” to receive terrestrial TV
broadcasting by an external antenna.
Select “Cable” if you are a Cable TV
subscriber not using an external set-top
box.
If you select “Cable”, the screen for
selecting the scan type appears. See “To
tune the TV for Cable connection” (page 9).
The TV then starts searching for all
available digital channels, followed by all
available analogue channels. This may take
some time, so do not press any buttons on
the TV or remote while proceeding.
~
• In some countries, you may select “Antenna”
instead of “Cable” to receive Cable TV
programmes.
If a message appears for you to confirm
the aerial connection
No digital or analogue channels were
found. Check all the aerial/cable
connections and press
to start auto-
tuning again.
3
Programme Sorting: Changes the order
in which the channels are stored on the
TV.
1 Press
F
/
f
to select the channel you
want to move to a new position, then
press
g
.
2
Press
F
/
f
to select the new position for
your channel, then press .
If you do not change the order in which the
channels are stored on the TV, press
HOME to go to next step.
~
• This step may not appear if only the digital
channel is found.
4
Set the current day and time.
~
• This step will appear only if clock has not been
obtained from digital broadcasting.
The message “Set-up complete.” will
appear on the screen. Press
.
The TV has now tuned in all the available
channels.
z
• USB System Update
You can update the TV system using USB memory.
Obtain information from the website below.
http://support.sony-europe.com/TV/
x To tune the TV for Cable connection
1
Press and
F
/
f
to select “Quick Scan”
or “Full Scan”, then press .
“Quick Scan” : channels are tuned
according to the cable operator information
within the broadcast signal.
Recommended setting for “Frequency” and
“Network ID” is “Auto”.
This option is recommended for fast tuning
when supported by your cable operator.
If the “Quick Scan” does not tune, please
use the “Full Scan” method below.
“Full Scan” : All available channels are
tuned and stored. This procedure may take
some time.
This option is recommended when “Quick
Scan” is not supported by your cable
provider.
2
Press
f
to select “Start”.
The TV starts searching for channels. Do
not press any buttons on the TV or remote.
~
• Some cable providers do not support “Quick
Scan”. If no channels are detected using “Quick
Scan”, perform “Full Scan”.
Select the broadcast type to automatically search for services
Digital and Analogue
Digital
Analogue
Skip
Auto Tuning
Back RETURN Select Back Next