5(E)
Setting the station number
Set the station number using the source/destination
select button 1 to 8. The station number is obtained by
adding the binary place values of the buttons that are
lit. For example, if the buttons 1, 2 and 4 are lit as
shown below, the station number is 11 (=1+2+8).
Note
Do not assign the same number to more than one unit
in a control system.
1
Press and hold the LOCK(CHOP) button and
PROT button 1 for about five seconds to reset the
software.
2
Press and hold the source/destination select buttons
1, 2, 3, and 4 to enter station number setting mode.
Note
When the power is turned ON for the first time,
station number setting mode is automatically set,
and steps 1 and 2 are not required.
3
Press the appropriate source/destination select
buttons so that the desired station number is
obtained.
4
Press the ALL/TAKE button.
The set station number is registered
Settings on the Control Terminal
Before switching signals with this unit, the
preparations should be made on the control terminal
connected to the primary station of the S-BUS data
link.
Preparation for the BKS-R3216
You may use up to 253 control units, including this
unit, in combination to expand the number of sources
and destinations, or use this unit alone. The required
settings may differ depending on whether it is used
alone or in combination. Make the necessary settings
shown below to suit your system.
When multiple units are used in combination, define
one as the mother unit and the others as daughter units.
Preparations
0
0
0
0
0
0
0
0
1
2
4
8
16
32
64
128
1 +
+
+
+
+
+
+
=
2
0
8
0
0
0
0
11
1
2
3
4
5
6
7
8
Examples of
setting a station
number 11
Not Lit
Lit
