17
Setting to 16-source select mode
While holding down buttons 1 and 4 (or 5 and 7), turn
the power on.
All the source/destination select buttons work as
source select buttons.
Setting to 8-source/8-destination select mode
While holding down buttons 5 and 6, turn the power
on.
Select buttons 1 through 8 function as source select
buttons, and select buttons 9 through 16 function as
destination select buttons.
Setting to phantom full-protect mode
While holding down buttons 9 and 11, turn the power
on.
If one of the crosspoints set for a phantom is protected,
switching of all the crosspoints of the phantom is
prohibited.
Setting to phantom partial-protect mode
While holding down buttons 9, 10 and 11, turn the
power on.
If one of the destinations set on a phantom is protected,
switching of the crosspoints, including the protected
destination, is prohibited, but the other crosspoints are
switched.
Entering station number setting mode
While holding down buttons 1, 2, 3 and 4, turn the
power on.
The station number can be set with binariy coding
using buttons 1 through 8.
Resetting the software
Press and hold the LOCK and PROT buttons for five
seconds. Then the software is reset, and the same
status as the power is turned on is obtained.
List of setup operations
Settings
Buttons to be
pressed
Initialization
1, 2
Single-use mode
5, 8
Prompt lamp-light mode
1, 3
Status display lamp-light mode
1, 2, 3
16-source select mode
1, 4 (or 5, 7)
8 source/8 destination select mode
5, 6
Phantom full-protect mode
9, 11
Phantom partial-protect mode
9, 10, 11
Station number setting mode
1, 2, 3, 4
