2-9 (E)
MAV-70
n
Place the removed HDD unit on the cushion with the
warranty label side down.
Installation procedures
1.
Insert a new HDD unit into the slot gently, and press
the levers in the direction of the arrows to lock the
HDD unit.
2.
Attach the HDD No.label which has same number as
removed HDD to the front of the new HDD unit.
.
HDD No. label : 3-605-401-01
3.
See the LCD display, and make sure that the status is
“Stp”.
4.
Install the front panel (lower). (Refer to the Section 2-
2-1.)
Starting the HDD
Set the menu select cursor to “Start”, and press the ENTER
key.
The drive will start, and a rebuild operation is automatical-
ly executed when spin-up of the drive is completed.
n
The menu “Service : Disks : Exchange” also enables you
to stop or start up a HDD. The menu “Service : Disks :
Exchange” is used to stop a HDD without “Req” (drive
exchange request).
Select and stop a HDD with extra care. If two or more
HDDs are selected, recording/playback may be disabled.
With a rebuild request for HDD has been generated, if
other HDD is stopped, recording/playback may be
disabled.
2-4. Replacement of Main Parts
HDD unit
Cushion
Label side down
Levers
HDD No.label
HDD unit
>Exit
Service : Disks
: Exchange
Mark
Stop
Start
Rdy Rdy Rdy Req Rdy Rdy Rdy Rdy
*
1
*
-2- -3-
*
4
*
-5- -6- -7- -8-
Exit
Disks : Exchange
>Stop
Start
Stp Rdy Rdy Rdy Rdy Rdy Rdy Rdy
*
1
*
-2- -3- -4- -5- -6- -7- -8-
Exit
Disks : Exchange
Stop
>Start
Stp Rdy Rdy Rdy Rdy Rdy Rdy Rdy
*
1
*
-2- -3- -4- -5- -6- -7- -8-
