3
Continue
3
Pull out the connector panel and remove
the connector panel cover.
4
Set all the DIP switches on the rear side of
the connector panel to OFF (down
position).
5
Connect the M board to the CN105
terminal on the A board of the monitor,
and connect the CN308 terminal on the Q
board of the connector panel to the
CN1202 terminal on the M board using the
supplied 4-pin harness.
CN1202
M board
CN105
CN308
6
Install the connector panel cover using 4
of the 6 screws removed in step 3.
7
Fasten the 4-pin harness and the two
harnesses from the connector panel to the
A board with the cord clamp (black).
8
Connect the 20-pin connector of the
remote interface to the REMOTE connector
on the connector panel, and fasten the
remote interface using the 2 remaining
screws from step 6 without catching the
wiring.
ON
1
2
3
4
REMOTE
IN
OUT
TALLY
Remove 6 screws