71
US
Set
tings
a
nd
Adj
u
st
m
e
nt
s
z
To adjust the level without listening to the test tone,
select “Level” in step 2 and press
, then adjust
the level using
V
/
v
, and press
.
◆
Level
You can vary the level of each speaker as
follows. Be sure to set “Test Tone” to “On”
for easy adjustment.
◆
Test Tone
Selects the signal type for the HDMI OUT
jack.
b
Select “2ch PCM” when connecting a TV or an AV
amplifier (receiver) that does not support Dolby
Digital or DTS, otherwise noise or no sound may
result.
Selects whether to mix or not mix interactive
audio and secondary audio (commentary)
when playing a BD that contains such audio.
b
PCM 96 kHz and PCM 192 kHz audio signals are
output as PCM 48 kHz audio signals when “BD
Audio Setting” is set to “Mix.”
Lowers the audio output level to prevent
sound distortion.
b
“Audio ATT” does not affect the output from the
HDMI OUT jack or DIGITAL OUT (OPTICAL/
COAXIAL) jack.
Front
Left
Front
Right
Adjust the level of the
front speakers (–12 dB to
0 dB, 0.5 dB increments).
(0 [dB])
Center
Adjust the level of the
center speaker (–12 dB to
0 dB, 0.5 dB increments).
(0 [dB])
Surround
Left
Surround
Right
Adjust the level of the
surround speakers (–12 dB
to 0 dB, 0.5 dB
increments). (0 [dB])
Surround
Back
Left
Surround
Back
Right
Adjust the level of the
surround back speakers
(–12 dB to 0 dB, 0.5 dB
increments). (0 [dB])
Subwoofer
Adjust the level of the
subwoofer (–12 dB to
0 dB, 0.5 dB increments).
(0 [dB])
On
The player emits a test tone
in sequence from the
MULTI CHANNEL
OUTPUT jacks to adjust the
sound level from each
speaker. When you select
one of the “Speaker
Settings” items, the test tone
is emitted from the selected
speaker.
Off
The test tone is not emitted
from the speakers.
Audio (HDMI)
Auto
Normally select this.
Outputs audio signals
according to the status of the
connected HDMI device.
2ch PCM
Downmixes to 2-channel
Linear PCM signals before
outputting from the HDMI
OUT jack.
BD Audio Setting
Mix
Mixes the interactive and
secondary audio as primary
audio.
Direct
Outputs the primary audio
only.
Audio ATT
On
Enables Audio Attenuation.
Off
Disables Audio Attenuation.
,
continued
