ATS-SW10Ti
10
3-8. DARR setting check
This mode is setting of EZW-RT10A is con
fi
rmed.
Procedure:
1. Enter the S-AIR test mode.
2. Press the [
M
]/[
m
] buttons on the remote commander to select
“DARR”.
3. Press the [ENTER] button on the remote commander, main
unit connect code is displayed on the liquid crystal display.
4. Press the [
M
]/[
m
] buttons on the remote commander, change
sub unit connection number, sub unit connect code and sub
unit address this order, and returns to the main unit connect
code display.
CO ****: main unit connect code
MUCNT **: sub unit connectoin number
MUCO****: sub unit connect code
MUADR **: sub unit address
5. Press the [ENTER] button on the remote commander, return to
S-AIR test mode each item.
3-9. Channel pipe setting
This mode is channel pipe is setting.
Procedure:
1. Enter the S-AIR test mode.
2. Press the [
M
]/[
m
] buttons on the remote commander to select
“CH 1 PIPE” (or “CH 2 PIPE”, “CH 3 PIPE”, “CH 4 PIPE”).
3. Press the [ENTER] button on the remote commander, the mes-
sages “CH* -> CH#” is displayed on the liquid crystal display.
*: channel number of selected step 2
#: number of channel pipe
4. Press the [
M
]/[
m
] buttons on the remote commander to select
channel pipe setting.
5. Press the [ENTER] button on the remote commander, return to
S-AIR test mode each item.
3-10. NAMG
setting
This mode is change of NAMG setting.
Procedure:
1. Enter the S-AIR test mode.
2. Press the [
M
]/[
m
] buttons on the remote commander to select
“NAMG”.
3. Press the [ENTER] button on the remote commander, the mes-
sages “AUTO” is displayed on the liquid crystal display.
4. Press the [
M
]/[
m
] buttons on the remote commander to select
the NAMG setting value. (“AUTO” or “000 SET” to “063
SET”)
5. Press the [ENTER] button on the remote commander, return to
S-AIR test mode each item.
(This mode setting value is buck up even if it turns off power)
3-11. Antenna
setting
This mode is setting of antenna.
Procedure:
1. Enter the S-AIR test mode.
2. Press the [
M
]/[
m
] buttons on the remote commander to select
“ANT SET”.
3. Press the [ENTER] button on the remote commander, the mes-
sages “T-* R-*” is displayed on the liquid crystal display.
*: 1, 2 or D
4. Press the [
M
]/[
m
] buttons on the remote commander to select
the antenna setting.
5. Press the [ENTER] button on the remote commander, return to
S-AIR test mode each item.
3-12. Display of recording permission information
This mode is con
fi
rmed whether it is a recording prohibition of the
music source the reproduction.
This mode is not used in servicing.
The display is “REC” in the S-AIR test mode is this mode. Please
return press the [ENTER] button on the remote commander when
it enters this mode by mistake.
Summary of Contents for ATS-SW10Ti Marketing
Page 12: ...ATS SW10Ti 12 MEMO ...
Page 47: ...MEMO ATS SW10Ti 47 ...
