65
Playing and Checking Recorded Contents
Cha
p
te
r 4
Re
co
rd
ing a
nd Pl
a
y
b
a
c
k
Playing and Checking
Recorded Contents
By pressing the PLAY button, you can review any length
of recording on the viewfinder screen in black and white or
in color on the LCD monitor. There are two other ways to
review the recording.
•
Recording review:
You can view the last two to ten
seconds of the recording on the viewfinder screen in
black and white or in color on the LCD monitor.
•
Playback in external color video monitor:
You can see
the recording in color on a color video monitor without
the need for any external adaptor.
For details about the switches and controls used to select
the audio output signal and to adjust the audio level, see
“Location and Function of Parts” on page 9.
Checking the recorded contents
immediately after shooting —
Recording Review
With recording paused, press the RET button on the lens.
The tape is automatically rewound over the last
approximately 2 seconds of the recording (approximately
10 seconds maximum if you press and hold the RET
button), and then this last part of the recording is shown in
the viewfinder and on the LCD monitor. Use this function
to check whether recording went correctly.
By assigning the LENS RET function to the ASSIGN
switch, you can use the switch in the same way as the lens
RET button.
For details, see “Assigning functions to ASSIGN
switches” on page 106.
• During recording review, do not set the POWER switch
to off. The camcorder may not be able to find the
continue point.
• You cannot start recording until the recording review has
finished.
Checking the recording on the color
video monitor
Connect a color video monitor to the MONITOR OUT
connector or the VIDEO OUT connector of the camcorder.
By pressing the PLAY button, you can view the recorded
picture.
For details about how to connect a monitor, see
“Connecting a Monitor” on page 40.
For the DSR-450WS/450WSP, only the picture displayed
through the camera is output to the CBK-SD01 SDI Output
Board. Playback pictures cannot be output even during
playback.
To use setup add (DSR-400/450WS only)
Setup add is a function that adds a setup to the playback
video signal. To activate this function, set SETUP ADD to
ON on the VTR MODE page of the MAINTENANCE
menu.
• The video image that connects the DVCAM format and
DV format is distorted during playback.
• The camcorder can play video and audio that is recorded
in DVCAM format or DV format (in SP mode).
• If two or more audio sampling frequencies are mixed on
one tape, the part where the video images are recorded in
different frequencies will be distorted.
Notes
Note
Notes
Summary of Contents for 400K - DSR Camcorder - 1.04 MP
Page 140: ...Sony Corporation ...
