Sony 1070, Handbook

Page: 53 / 132

53
Usi
n
g t
h
e S
e
tu
p i
tem
s
Automatically activates the electronic
shutter to adjust the shutter speed when
recording in bright conditions if you set it to
[ON] (the default setting).
You can select and adjust the focal point to
aim it at a subject not located in the center of
the screen.
1
Touch the subject on the screen.
9 appears.
2 Touch [END].
To adjust the focus automatically, touch
[AUTO]
t
[END] in step 1 .
• If you set [SPOT FOCUS], [FOCUS] is
automatically set to [MANUAL].
• The setting returns to [AUTO] after you remove
the power source for more than five minutes.
You can adjust the focus manually. Select this
when you want to focus on a certain subject
intentionally.
1
Touch [MANUAL].
9 appears.
2
Touch (focusing on close subjects)/
(focusing on distant subjects) to
sharpen the focus.
appears when the focus cannot be
adjusted any closer, and appears when
the focus cannot be adjusted farther away.
3 Touch .
To adjust the focus automatically, touch
[AUTO]
t in step
1
.
• It is easier to focus on the subject by moving the
power zoom lever towards T (telephoto) to adjust
the focus, then towards W (wide angle) to adjust
the zoom for recording. When you want to record
a subject at close range, move the power zoom
lever to W (wide angle), then adjust the focus.
• The minimum distance required between your
camcorder and the subject to get a sharp focus is
about 1 cm (about 1/2 inch) for wide angle and
about 80 cm (about 2 5/8 feet) for telephoto.
• The setting returns to [AUTO] after you remove
the power source for more than five minutes.
You can set this function when you use an
external flash (optional) that is compatible
with your camcorder. Attach the external
flash to the Active Interface Shoe (p.76).
x FLASH MODE
B
ON
Always flashes when recording still images.
ON
Always pre-flashes to reduce redeye
phenomenon, then flashes when recording
still images
AUTO
Always flashes automatically.
AUTO
Always pre-flashes automatically to reduce
redeye phenomenon, then flashes
automatically when recording still images.
• If the flash is not capable of preventing the redeye
phenomenon, you can select only [ON] or
[AUTO].
• The setting returns to [ON] after you remove the
power source for more than five minutes.
AUTO SHUTTER
SPOT FOCUS
FOCUS
SPOT FOCUS STBY
AUTO END
FLASH SET (DCR-SR60/SR80)