4
Commissioning
and installing
SONAPHONE T
10
4
Commissioning and installing
4.1
Inserting the batteries
Caution!
Make sure you install the batteries in the correct position. The device may
be damaged if they are not properly fitted.
The correct position for installing the batteries is shown on the device.
Unscrew the battery compartment cover.
Insert the batteries into the battery compartment according to the
illustration on the bottom of the device.
When the device is operational, the battery (1.5 V) status is shown on the
display.
Appropriate accumulators can also be used to operate the device. The
charge status for the accumulators (1.2 V) is then shown approximately.
4.2
Connecting the power supply unit
The power supply unit has no charging function.
Unscrew the protective cover for the power supply connection.
Connect the power supply unit.
The device recognises the connection of the power supply unit – even
when it is operating – and automatically switches over to mains power
operation.
4.3
Installing probes
Caution!
Make sure the probe connector is in the correct position. The device and
the probe may be damaged during installation.
The slot for probes is provided with a notch which indicates the correct
position for insertion.
Install the required probe in the specified position. You must feel the
connector click into place.
The probe is installed and ready to use.
