SonoSite C1.9 PLUS, Service Manual

Page: 32 / 98

24 C1.9 PLUS Ultrasound System Service Manual
To remove the battery:
1. Turn off the system.
2. Locate the battery compartment at the bottom of the system.
WARNING:
`
If you are holding the system, when you remove the battery, place your hand
beneath the battery. If it falls to the floor, it could be damaged, or cause personal
injury.
3. To release the battery, press the battery release button (lower, right side) on the
system.
4.4 Using AC Power
The battery charges when the system is using AC power. If the system is off and
connected to AC power, a fully discharged battery will charge in about three hours.
To operate the system using AC power:
1. Connect the line cord to the AC power adapter.
2. Connect the line cord to a hospital-grade electrical outlet.
3. Connect the AC power adapter to the system using the upper, left connector on
the left side of the system. (Figure 4.3).
Note: You must wait approximately 10 seconds after connecting to AC power before
turning on the power switch
.
Figure 4.3 System Connections
Table 4.1 System Connections
NUMBER FEATURE
1 DC line voltage connector
2 I/O connector
3 Print control connector for a recommended printer
4 Video out connector for a recommended VCR, printer, or external video
monitor
1 2 3 4