Sonoro iElements Page 45 Instruction Manual Download

Page: 45 / 184

gli

8.2 Alarm

Your iElements can wake you up with a radio station or a pleasant alarm tone. You can set

the volume of the alarm and use the so-called snooze function.

You can set the alarm when the iElements is switched on as well as when the device is

switched off. In both cases press the menu button and then use the << and >> buttons to

navigate through the options until

ALARM

appears on the display. Confirm your selection by

pressing the menu button.

Now you can activate the alarm (

ALM ON

) or deactivate it (

ALM OFF

) with the + and –

buttons and confirm your selection with the menu button. If you select

ALM OFF

, the setting is

cancelled. You can recognise an active alarm by the small alarm symbol on the display.

When you have selected

ALM ON

, you can set the wake-up time. This is selected in the same

way as setting the display time with the +/- and <</>> buttons. Confirm your selection with
the menu button.

SOURCE

then appears on the display and you can decide which signal you would like to be

woken by. The frequency ranges

and

as well as an alarm tone (

BEEP

) are available.

Make your selection with the << and >> buttons and confirm it with the menu button. If you

select a radio station, you can use the stations you have saved in the presets. Use the + and

- buttons to select from the 10 memory presets 0…9 for each frequency band.

VOLUME

then appears on the display and you can select the alarm volume of your signal

source with the + and – buttons. As soon as the alarm starts, the volume is slowly increased
until it reaches the level you have selected. When you confirm your selection with the menu
button, the alarm has been set.

ALARM ON

appears on the display.

NOTE!

When setting the alarm time, please pay attention to the selected time format.

You can recognise an active alarm by the alarm symbol on the display. Before
using this function for the first time, test the different alarm volumes to find a
level that is suitable for you. If you have connected a device to the

headphones socket, please note that the alarm tone will only be output
through this device. This means, for example, that you may not be able to

hear the alarm if the headphones have slipped. Please make sure that you
switch off the alarm, for example, if you go on holiday.

You can switch off an active alarm by pressing the menu button for approximately two

seconds. The alarm will stop and the small alarm symbol on the display stops flashing.

If you want to temporarily suppress an active alarm rather than turning it off, you can use the

snooze function. Briefly press the menu button once when the alarm is activated.

SNOOZE

then appears on the display and you can use the + and – buttons to set the number of
minutes after which the alarm should be switched on again. The default setting is 5 minutes.
Once you have made your selection, please confirm it with the menu button. The small alarm
symbol on the display continues to flash and is reactivated after the time you have set. If you