Sonnit Looper Sonnit Pedal, Manual, Page: 7 / 18

6.Audio Routing Options
Although the input and output options are not functions of the pedal you will find 4 options for
routing your audio signals through your audio interface and the correct in/out setup for the
software:
●
6.1. This is for a simple 2 In 2 Out setup. It uses input monitoring so both the guitar signal and
mic signal run straight through the software for monitoring.
●
6.2. This gives you 2 In 4 Out, again using input monitoring. This means you will have your
guitar and mic signal running straight through the software on Output 1 and 2 with your loops on
Output 3 and 4.
●
6.3. This gives you 2 In 2 Out but without using input monitoring. This means you have an
isolated vocal and mic track running separately to the PA/Amp and your loops running out of
Output 1 and 2 on your audio interface, allowing the guitar, mic and loop tracks to be mixed
individually.
●
6.4. This is a 2 In 4 Out setup without input monitoring. This setup gives you full control of the
mic, guitar and each of the 4 loop tracks individually.