Sonnenkonig MAXIMO 1000, Manual

Page: 46 / 50

46
5 Operation
5.1 Commissioning
5.2 Thermostat
To use the heater, proceed as follows:
• Plug the power cord to the power circuit.
• Press the power switch to on position.
• Operate the unit then according to the following description.
You can set the desired temperature by thermostat. Turn the thermostat to the desired
value. The heater is then up to the attainment of the preset value to a maximum opera-
tional level.
The thermostat will cause the heater to turn on when the ambient temperature is below
the preset value. If the temperature rises above this value, the thermostat, the unit swit-
ches to the ECO-saving function.
5.3
Thermostat / Timer
(Heater Maximo 2000 LCD)
Press the MODE button, the unit turns on and begins to heat up.
There are 3 different modes:
1. LOW Drücken Press the MODE button 1x and this mode is activated.
You can in this mode does not adjust the temperature.
The temperature is LOW (low) .
Set the timer, you can use the + and - buttons.
Press to confirm the set time , the timer button.
The appliance now heats example for 2 h and then turns off.
2. HIGH Drücken Press the MODE button 2x and this mode is activated. You can
in this mode does not adjust the temperature. The temperature is
HIGH (high). Set the timer, you can use the + and - buttons. Press
to confirm the set time, the timer button.The appliance now heats
example for 2h and then turns off.
E