26
GB
2 Instructions for Use
Horizontal
oscillation
High
Low
Power
(flame effect)
1. Connect the device to the power supply.
2. Press the power switch
to start the flame effect.
3. For the heating function press the switches
and
(the device cannot operate if
is not pressed first).
4. For the shaking function press the switch
.
5. Note that the function of the flame effect is independent of the heating function. This
means you can turn on the flame effect without turning the heater on.
3 Overheating Safety Device
Your heater is fitted with a safety device that switches off the heater in case of overheating.
If the heater stops working, turn the heater off and check the inlet and the outlet for any
blocking object. Disconnect the plug and wait for at least 10 minutes for the protection
system to reset before attempting to restart the heater. If the safety device still switches
the heater off and makes the heater fail to operate, take the heater to your nearest ser-
vice centre for examination or repair.
Attention
: Before restarting the heater, the plug must be disconnected for at least 10 minutes.
