Sonnenkonig 10000202, User Manual

Page: 60 / 64

60
EN
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTION
Unit does not start when
pressing the on/off button.
Water full indicator lamp blinks and
water tank is full.
Dump the water out of the water
tank.
Room temperature is lower than the
set temperature (cooling mode).
Reset the temperature.
Not cool enough. The doors or windows are not closed. Make sure all the windows and doors
are closed.
There are heat sources inside the
room.
Remove the heat sources if possible.
Exhaust air hose is not connected or
blocked.
Connect or clean the exhaust air
hose.
Temperature setting is too high. Reset the temperature.
Air inlet is blocked. Clean the air inlet.
Noise The ground is not level or not fl at
enough.
Place the unit on a fl at, level
ground if possible.
The sound comes from the fl owing of
the refrigerant inside the air condi-
tioner.
This is normal.
Code E0 Room temperature sensor failed. Replace the room temperature
sensor (the device can also work
without a replacement).
Code E2 Evaporator temperature sensor failed. Replace evaporator temperature
sensor.
Code E3 Water tank full. Please empty the water tank.
8. TROUBLESHOOTING
VERY IMPORTANT! Please do not install or use your mobile air conditioner until you have carefully read this
manual. Please keep these operating instructions for possible product warranty and later reference.
WARNING! Do not use any means other than those recommended by the manufacturer to speed up the
defrosting process or to clean the appliance. The appliance must be stored in a room without regularly
operated ignition sources (e.g. naked fl ames, a gas appliance or an electric heater). Do not puncture or
burn. Note that the refrigerants must not contain any odours.
CAUTION
Fire hazard