68
•
After the unit is switched on, to operate the fan, the compressor will start up after the cooling alarm
has flashed for three minutes.
•
In heating mode, the heating alarm will flash for 3.5 minutes before the compressor and fan start up.
•
If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or a similar-
ly qualified person in order to avoid a hazard.
•
In order to dispose of the appliance safely, please remove the batteries from the unit before discar-
ding it.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety. Children
should be supervised to ensure that they do not play with the appliance.
•
Please drain out water before moving the unit.
•
Do not install the unit in a laundry room.
•
The unit should be installed in compliance with national electrical wiring regulations.
Attention!
For effective heating and cooling, please ensure that the following steps are followed.
Extend the exhaust hose to a maximum lenght of 400 mm. The exhaust hose must be kept
parallel and must not be bent up or down.
•
A distance of at least 500 mm must be kept between the filter side of the unit and any walls
or other obstacles.
•
When the appliance starts to defrost, “dH” will be displayed on the LED display
EN
